ST 410A/B Two- Component Silicone Structural Adhesive and Sealant

ST 410A ST 410B

ST 410A/B is a one-component, high-performance, neutral-curing silicone two-component structural adhesive sealant. It exhibits excellent adhesion to most materials, including aluminum alloys, stainless steel, microcrystalline glass, and ABS+PC, and is weather-resistant, resistant to high and low temperatures, and cures quickly.

Get A Free Quote

Main uses

Insulating glass and glass curtain wall elastic structure bonding and sealing ;

Elastic structure adhesive sealing for subway platform screen doors;

Packaging

ST410A: 200L iron drum; ST410B: 20L plastic drum.

Calculation of glue application length

Thickness (mm)	Width ( mm)
Thickness (mm)	6	9	12	15	18	twenty one	twenty four
6	16.4	10.9	8.2	6.6	5.5	4.7	4.1
9	10.9	7.3	5.5	4.4	3.6	3.1	2.7
12	8.2	5.5	4.1	3.3	2.7	2.3	2.0

Note: The actual amount of sealant used may vary depending on the interface design, the installation location of the gasket material, the finishing technique, and the amount of waste on site.

Storage and Shelf Life

Store in a well-ventilated and dry place at 5-25℃, avoiding direct sunlight. Shelf life is 9 months.

Safety Precautions

This product is non-toxic once fully cured, but contact with eyes should be avoided before curing. If contact with eyes occurs, rinse thoroughly with plenty of water and seek medical attention immediately. Uncured products should be kept out of reach of children.

Users are advised to thoroughly understand the product and its performance before using it, and to conduct compatibility tests. Due to the diversity of practical applications, our company does not guarantee against problems arising from the use of our products under specific conditions. Users encountering any problems during use can communicate with our engineers.

We will do our best to provide you with the best product application solutions.

Inspection Test item Head		index
Sagging	Vertical placement mm	≤ 3
Sagging	Horizontal placement	No deformation
Extrudability, s		≤ 10
Surface drying time, h		≤3
Hardness, HsA		20 ～ 60
Elongation at maximum tensile strength (%) at 23℃		≥100
Tensile adhesion MPa	Standard allow strip Item	≥ 0.70
	90 ℃	≥ 0.50
	-30 ℃	≥ 0.50
	After soaking in water	≥ 0.50
	Water after ultraviolet light exposure	≥ 0.50
	Bond failure area, %	≤5
thermal aging	Thermal weight loss, %	≤5
	Cracks	none
	Powdering	none